ここから本文です
TWO:4. The loss of power by friction and angles in conducting air through pipes.
Classification by type of system
1natural circulation external heating pipe type
2natural circulation calandria type
3forced circulation type
4falling-film type
5rising film type
6jacket type
7coil type
Classification by method of operation
1single effect evaporator system
2multiple effect evaporator system
3auto-vapor mechanical compression system
4auto-vapor ejector compression system
5multistage flash system

After taking into consideration of the physical and chemical property of solutions, the desired design conditions, and available utilities, we select the most suitable type of system by utilizing our years of experience and excellent results.
In addition, we can offer designs and manufacturing services that take into careful consideration compactness, energy-efficiency, and automatization.

THREE:My request to allow the child to stay at the caf for half an hour was granted, and I went through the village towards the place whence the German batteries sent their destructive fire. At last I got as far as the top of a hill, from which I could see two forts shrouded in a cloud of smoke, which was also the case with the German batteries.

While standard calandria type evaporation systems are widely used as the typical concentration evaporator by the various food and chemical industries, we have delivered many of those systems as finishing concentration evaporators especially for sugar solutions and starch syrups.

THREE:"Murder!" he yelled. "Police, arrest that woman; she has tried to kill me!"CHAPTER XXV. A CHECK.
  • Enables flexible operation with little influence from variations in load and raw solution concentrations because of an adequate amount of solution being held within the system. These systems are also suitable for batch type burning evaporators.
  • Concentrations can be controlled within product specifications by the cascade control using the concentrations of concentrated solution and the raw solution supply and also by the arithmetic control of raw solution concentrations, etc. (Result for sugar solutions: 75±0.2wt%)
  • High-viscosity solutions and solutions that may crystallize can also be utilized by installing a propeller in the evaporator as a forced circulation system.
THREE:"Pursue a policy of masterly inactivity," Lawrence suggested after a thoughtful pause. "Say nothing for the present. The matter has not been brought before you officially yet. There will be an inquest, which will only last a few minutes, for the simple reason that the police will ask for an adjournment. Meanwhile I will go and have a chat with the man who has the case in hand. If the time comes when you must speak, why speak, of course."Round about Louvain everything was prepared for defensive purposes, artillery being hidden under straw-roofs, only a few yards away from the farm-houses, and the sentries were very alert. I never saw them before I was quite near; then they jumped suddenly from behind a tree, summoning me to stop by lowering their rifle. In the meadows were a good many newly cut trenches.

This is a process example of a device that continuously and simultaneously concentrates two types of waste liquid with a single high-efficiency steam compressor.

THREE:I took the liberty to explain to the officer that the man did not understand him, and stated that he did not know me.
  • By evaporating the steam using a mechanical compressor and reusing it, almost no heating steam is alomost required except the time of start-up, so large energy savings can be expected.
  • By combining with a thin film falling heat exchanger that does not raise the boiling point due to the liquid depth, it is possible to utilize the temperature difference of the compressor at the maximum.
  • Since the residence time and heating time are short and the holding amount is small, starting and stopping can be performed in a short time.
  • It will prevent scale adhesion in the can that the evaporator is divided into two parts, and that the supply of the undiluted solution is alternately switched over a fixed period of time to perform heat concentration.